The rammer hammer is a commonly used earthwork equipment that compacts the soil and improves the bearing capacity of the foundation. In the process of using ramming hammer, due to long time use and wear, sometimes need to replace the hammer head. The following is a detailed description of the operation steps for strong rammer hammer replacement.
Step 1: Preparation
Before replacing the hammer head of ramming hammer, you need to stop the ramming hammer from working and place it on a smooth ground. Then, you need to prepare the tools needed to replace the hammer head and spare hammer head.
Step 2: Remove the old hammer head
First, you need to use a wrench to loosen the nut on the old hammer head and remove the old hammer head from the tamper. In the process of removing the old hammer head, you need to pay attention to safety to avoid the hammer head falling or injuring people.
Step 3: Clean the rammer
After removing the old hammer head, you need to clean the rammer. You can use cleaners and brushes to clean the dirt and oil on the surface of the rammer so that the new hammer head can be replaced.
Step 4: Installation of the new hammer head
After cleaning the rammer hammer, you need to install the spare hammer head onto the rammer hammer. First, the new hammer head needs to be placed on the rammer and secured with a nut. During the process of fixing the nut, you need to pay attention to the strength to avoid too tight or too loose.
Step 5: Testing
After replacing the new hammer head, the tamper hammer needs to be tested to ensure that it works properly. You can connect the ramming hammer to the power supply, test run, observe the working condition and vibration of the hammer head to ensure that the replaced hammer head can work properly.
In short, replacing the hammer head of the ramming hammer is a relatively simple operation, but it needs to pay attention to safety and details. Before replacing the hammer head, you need to do a good job of preparation, pay attention to safety when dismantling the old hammer head, and pay attention to strength and fixation when replacing the new hammer head. After the replacement is completed, it needs to be tested to ensure that the strong rammer hammer can work properly.